Cellphone adapter (rotating) and Original CP-10 Camera Quick Release Plate for Targus Tripod Model MX-2000P
(New Generation, also sold as Walmart or OSN Brand)

IMPORTANT: The MX2000 was made with TWO different heads. This is ONLY for the tripods that show MX2000P in the well where the quick release plate goes.

Note: in third & fourth photo above it shows the platform well or quick release receiver. For this model it should NOT be blank. It MUST say MX2000P as seen in the photo above and should be 43mm wide or 1 5/8" wide.

• base dimension of plate is: 43mm x 43mm  (your opening should be 43mm wide or 1 5/8")
• top dimension is approximately: 40mm x 60mm
• features a 1/4"-20 camera screw plus a video pin.

If you have the other MX2000 tripod, I have the correct Quick Release plate for that MX2000 here https://www.ebay.com/itm/332689469007
Phone holder fits phone up to the size of an iPhone 11 Pro Max or XS Max, or any phone up to 4.13" wide
Any questions. please ASK BEFORE ORDERING.

A quick release plate will attach to the camera's tripod mount and allows you to quickly and easily attach or remove the camera from a compatible tripod without having to waste time fumbling with the threaded mount.

Having the same number of quick release plates as the number of cameras and/or large telephoto lenses in use allows you to leave one on each, enabling the rapid change of equipment with minimal fuss, essential for the professional or advanced amateur photographer. Always good to have a spare
(plus you'll SAVE Up To 20% or more on your entire order if you buy 2 or more today! )

SATISFACTION GUARANTEED
Thanks, Owen (okdnet-emporium)

Powered by SixBit's eCommerce Solution