AP-8067 2K Primer Sealer White Quart

Kit Includes:

1 - Quart Primer 

1 - Half Pint Activator

AP-8067 is a premium non-sanding urethane sealer to also be used with the Euro Catalysts. Sprays on smoothly and has excellent opacity for a slick topcoat finish and uniform ground coat for repairs. Available in gallons and quarts. Mix 4:1 with either medium or fast urethane catalysts (AH6270 and AH6280).

AP-8067 2K Primer-Sealer is a two-component acrylic urethane primer sealer formulated to be applied as a low build non sanding sealer. AP-8067 offers excellent filling properties with minimal coats, fast dry, excellent adhesion, easy sanding and superior color holdout. AP-8067 does not shrink and can be tinted with basecoat tints. This product is also available in black under the part number AP-8066. 

Surface Preparation, Bare Substrates: Solvent wash surface with a good grade wax and grease remover such as AS-2900 and wipe dry with a clean cloth. Apply 1-2 wet coats of AP AP-8300 Series Epoxy Primer according to instructions on data sheet. 

 Surface Preparation, Prepainted Substrates: Wash surfaces with a mild detergent and hot water. Rinse with clean water and wipe dry with a clean cloth. Solvent clean with AS-2900 Clean Ease. Wipe dry with a clean cloth. Sand original paint and repair damaged areas with a good quality non-staining body filler. For spot repairs, scuff sand area where sealer will be applied. For overall refinishing, scuff sand the entire car with 320 grit sandpaper or fine scuff pad. 

Mixing Directions, Sealer:  4 Parts (AP-80xx Gray or Black) 2K Sealer 1 Part AH-6270, AH-6280 Activator Series 

Application: Adjust air pressure at the gun to 30-45 psi for siphon or gravity feed guns. Pressure for HVLP guns should be 6-8 lbs at the aircap. Use less pressure to minimize over spray on small jobs. Apply 1-2 medium wet coats at a gun distance of 8 -12 inches as needed to achieve coverage. Allow 10 to 20 minutes flash time between coats. Recoat times will vary with temperature, air movement and film thickness. Insufficient flash time will promote slow hardness development of the topcoat system.

MADE IN THE USA

Ship to the lower 48 states ONLY!!!!

Always wear an approved spray mask and gear.