Features:
  • MCU is supplied to control the gate operator.
  • Keypad / single button interface.
  • Photo beam safety beam interface.
  • User can select Auto-close function.
  • Manual key release design for emergency purposes.

Main technical parameters

Type

PY800AC (L)

PY800ACU (L)

PY1400AC (L)

PY1400ACU (L)

Power supply

220V, 50Hz

110V, 60Hz

220V, 50Hz

110V, 60Hz

Motor speed

52rpm

62rpm

52rpm

62rpm

Rated output power of motor

360W

500W

Output shaft height

58.5mm

Max. gate weight

800kg (1800lb)

1400kg (3100lb)

Output torque

18N·m

25N·m

Noise

?60dB

Duty cycle

S2, 15 minutes

Remote capacity

20

Environmental temperature

-20°C~+50°C

Gate Move speed

11m/min

13m/min

11m/min

13m/min

Mechanical Installation
The PY800AC?L) /PY1400AC?L) will handle gate weighting up to 800kg/1400 and up to 14m/20 if the proper installation procedures have been followed.
The PY800AC?L) /PY1400AC?L) gate operator operates by forcing a drive rack by a drive gear. The entire configuration is shown in the diagram below. The gate operator must be installed on the inside of the gate.

The PY800AC?L) /PY1400AC?L) Chain-driven Gate Operator operates by forcing a straight piece of chain through its chain box. This length of chain is extended between two chain brackets located at opposite ends of the gate. The entire configuration is shown in the pack list.

Gate preparation
Be sure the gate is properly installed and slides smoothly before installing the PY800AC?L) /PY1400AC?L) sliding gate operator. The gate must be plumb, level, and move freely.

Conduit
In order to protect the cable, use PVC conduit for low voltage power cable and control wires. Conduit must be preset into the concrete when it is poured. Wires within the conduit shall be located or protected so that no damage can result from contact with any rough or sharp part.

Concrete Pad
The base unit of the gate operator requires a concrete pad in order to maintain proper stability. The concrete pad should be approximately 24” (600mm) x 12” (300mm) x 18” (460mm) deep in order to provide for adequate operation. Once the gate is mounted adequately, electrical power is available, and the concrete pad is poured, you are ready to proceed.

Anchors
You can use the anchors that are provided with the operator, 3 ¾ anchor bolts (4), anchors, washers, and nuts. These anchors must be set into the concrete when it is poured, or you can use wedge anchors (1/4” x 4”).

Operator Base
Mount the gate operator base to the concrete pad. The distance between the gate and the base should be no more than 2 ½ “ (64mm). Verify that the operator is leveled properly.

Package Include
* Main Unit (1 PC)
* Control Board (1 PC)
* 2 Remote Controls
* 20ft of Chain (4 PCs)
* Photo-eye Sensor (1 PC)
* Mounting Brackets
* Hardware and Concrete Pad mount
* Manual

More information can be found on the operator manual

We offer 2 models 110v and 220v (We send to USA customers 110v and Europe 220v unless specified by the customer), rack can be steel or nylon (default we send steel)